Users Guide
EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
delay-restore abort-threshold
Increase the Boot Up timer to some value (>60 seconds).
Syntax
delay-restore abort-threshold <interval>
To remove use the no delay-restore abort-threshold command.
Defaults 60 seconds
Command Modes VLT DOMAIN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000–ON and Z9500.
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to abort. This timer is applicable
only during reload/boot-up and not in other scenarios (example, ICL ap).
The range is from 1 to 1800 seconds.
Usage Information To abort VLT delay restore timer as the maximum threshold, the maximum time interval is applied to hold down ICL
peer-up in the start-up congurations during the reload.
io-aggregator auto-lag enable
Enable auto-lag globally on the server facing ports
Syntax
io-aggregator auto-lag enable
To disable the auto-lag, use the no io-aggregator auto-lag enable command.
When disabled, all the server ports associated in a LAG are removed and the LAG itself gets removed. Any
LACPDUs received on the server ports are discarded.
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes
Standalone, Stacking, VLT
252 Link Aggregation Control Protocol (LACP)