Users Guide

tdr-cable-test
Test the condition of copper cables on 100/1000/10GBase-T modules.
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword TenGigabitEthernet followed by the slot/port information for the
100/1000/10GBase-T Ethernet interface.
Defaults none
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test tengigabitethernet 5/2
%Error: Interface is disabled TenGIG 5/2
Related Commands show tdr — Displays the results of the TDR test.
vlan tagged (CMC)
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
vlan tagged [vlan-id]
To remove a tagged interface from a VLAN, use the no vlan tagged vlan-id command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
If the interface belongs to several VLANs, you must remove it from all VLANs to change it to an untagged
interface.
Interfaces 225