Users Guide

Overlapping Port
Ranges
Only VLAN and port-channel interfaces created using the interface vlan and vlan tagged commands can
be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-
channel interfaces that are not displayed in the show running-config command cannot be used with the
bulk conguration feature of the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical, and port-channel interfaces, only commands related to physical
interfaces can be bulk congured. To congure commands specic to VLAN or port-channel, only those
respective interfaces should be congured in a particular range.
Example-Single
Range Bulk
Conguration
Dell(conf)# interface range tengigabitethernet 5/1 - 23
Dell(conf-if-range)# no shutdown
Dell(conf-if-range)#
Example-Multiple
Range Bulk
Conguration
Gigabit Ethernet and
Ten Gigabit Ethernet
The following example shows how to use commas to add dierent interface types to the range enabling all
TenGigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2.
Dell(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet
1/1 - 2
Dell(conf-if-range)# no shutdown
Dell(conf-if-range)#
Example-Multiple
Range Bulk
Conguration with
VLAN and port
channel
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet
1/1 – 2,
Vlan 2 – 100 , Port 1 – 25
Dell(conf-if-range)# no shutdown
Dell(conf-if-range)#
Related commands show cong (from INTERFACE RANGE mode)— Shows the bulk conguration interfaces.
show interfaces status— Displays a summary of interface information.
interface vlan
Congure a VLAN. Congure the default VLAN to enable Static or DCHP IP conguration. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identier. The range is from 1
to 4096.
Defaults Not congured, except for the default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Interfaces 197