Users Guide

Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode,
ensure that the interface’s conguration does not contain an IP address and enter the Port Channel
Commands
command. By default, in PMUX mode, the interface is shut down when the portmode hybrid and
switchport are enabled.
The tunnel interface operates as an ECMP (equal cost multipath) only when the next hop to the tunnel destination
is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel
interface does not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#exit#
Related Commands
interface port-channel — congures a port channel.
interface vlan — congures a VLAN.
show interfaces — displays the interface conguration.
interface ManagementEthernet
Congure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet, then the slot number (0) and port number
zero (0).
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4.(0.0) Supported on the FN I/O Aggregator and M I/O Aggregator.
Usage Information
You cannot delete a Management port.
194 Interfaces