Users Guide

ip igmp snooping mrouter
Statically congure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword gigabitethernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed
by the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router is
attached. To congure a static connection to the multicast router, enter the ip igmp snooping mrouter
interface command in the VLAN context. The interface to the router must be a part of the VLAN where you
are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Internet Group Management Protocol (IGMP) 181