Users Guide

Command History
Version
9.9(0.0) Supported on the FN I/O Aggregator.
9.7(0.0) Introduced on the M I/O Aggregator.
Example
Dell(conf)#fc zoneset test1
Dell(conf-fc-zoneset-test1)#member ?
WORD Zone Name
Dell(conf-fc-zoneset-test1)#member
Related Commands
show fc zoneset — displays the congured and active zoneset.
show fcoe-map — displays the fabric parameters.
fcoe-map
Create an FCoE map which contains the parameters used to congure the links between server CNAs and a SAN fabric. Apply the FCoE
map on a server-facing Ethernet port.
Syntax
fcoe-map map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes CONFIGURATION
INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator.
Usage Information
An FCoE map is a template to map FCoE and FC parameters in a converged fabric. An FCoE map virtualizes
upstream FC ports on the switch NPIV proxy gateway to appear to downstream server CNA ports as FCoE
forwarder (FCF) ports on an FCoE network. When applied to FC and Ethernet ports on an NPIV proxy gateway, an
FCoE map allows the switch to operate as an FCoE-FC bridge between an FC SAN and an FCoE network. It
provides necessary parameters to FCoE-enabled servers and switches to log in to a SAN fabric.
On the switch NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and server-facing Ethernet
ports. Use the fcoe-map command to apply an FCoE map on an Ethernet port. Use the fabric command to
apply an FCoE map on an FC port.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN for storage trac, the destination
SAN fabric (FC-MAP value), FCF priority, and the FIP keepalive (FKA) advertisement timeout.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in Interface
conguration mode.
NOTE: You cannot create fcoe-map in IOA mode. It can only be created in PMUX mode.
154 FC FLEXIO FPORT