Users Guide

Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
dot1p priority trac on the switch is scheduled to the current queue mapping. dot1p priorities within the same
queue must have the same trac properties and scheduling method.
ETS-assigned scheduling applies only to data queues, not to control queues.
The conguration of bandwidth allocation and strict-queue scheduling is not supported at the same time for a
priority group. If you congure both, the congured bandwidth allocation is ignored for priority-group trac when
you apply the output policy on an interface.
Related Commands
• bandwidth-percentage — bandwidth percentage allocated to priority trac in port queues.
show dcb
Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-enabled queues.
Syntax
show dcb [stack-unit unit-number]
Parameters
unit number Enter the DCB unit number. The range is from 0 to 5.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Specify a stack-unit number on the Master switch in a stack.
Example
Dell#show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Queue Count : 2
Total Buffer[lossy + lossless] (in KB) : 3822
PFC Total Buffer (in KB) : 1912
PFC Shared Buffer (in KB) : 832
PFC Available Buffer (in KB) : 1080
Data Center Bridging (DCB) 117