Reference Guide

Data Center Bridging | 97
dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the no dcbx version {auto | cee | cin | ieee-v2.5} command.
Parameters
Defaults
Auto
Command Modes
PROTOCOL LLDP
Command
History
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch.To verify
the DCBX configuration on a port, use the
show interface dcbx detail command.
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Defaults
ETS mode is on.
Command Mode
DCB OUTPUT POLICY
Command
History
auto | cee | cin |
ieee-v2.5
Enter the DCBX version type used on the interface, where:
•
auto: configures the port to operate using the DCBX version received from a
peer.
•
cee: configures the port to use CEE (Intel 1.01).
•
cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0).
•
ieee-v2.5: configures the port to use IEEE 802.1az (Draft 2.5).
Version 8.3.17.0 Supported on M I/O Aggregator
Version 9.2(0.0) Supported on the M I/O Aggregator