Reference Guide

Control and Monitoring | 75

Command

History

Usage

Information

This command enables XML input mode where you can either cut and paste XML requests or enter the

XML requests line-by-line.

terminal monitor

Configure the FTOS to display messages on the monitor/terminal.

Syntax

terminal monitor

To return to default settings, use the no terminal monitor command.

Defaults

Disabled.

Command Modes

EXEC

EXEC Privilege

Command

History

traceroute

View the packet path to a specific device.

Syntax

traceroute {host | ip-address}

Parameters

Defaults

Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434

Command Modes

EXEC

EXEC Privilege

Command

History

Usage

Information

When you enter the traceroute command without specifying an IP address (Extended Traceroute), you

are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count

(default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is

33434). To keep the default setting for those parameters, press the ENTER key.

Version 8.3.17.0 Supported on M I/O Aggregator

host

Enter the name of device.

ip-address

Enter the IP address of the device in dotted decimal format.

Version 8.3.17.0 Supported on M I/O Aggregator