Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator
51525354555657585960
52 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
Example
Figure 5-6. show configuration lock Command Output
Usage
Information
The type may be auto, manual, or rollback. When set to auto, FTOS automatically denies access to
CONFIGURATION mode to all other users every time the user on the listed VTY line enters
CONFIGURATION mode. When set to manual, the user on the listed VTY line must explicitly set the
lock each time before entering CONFIGURATION mode. Rollback indicates that FTOS is in a
rollback process. The line number shown in the output can be used to send the messages to that session
or release a lock on a VTY line.
show cpu-traffic-stats
Displays the CPU traffic statistics.
Syntax
show cpu-traffic-stats [port number | all]
Parameters
Defaults
all
Command Modes
EXEC
Command
History
Example
Figure 5-7. show cpu-traffic-stats Command Example
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS# show configuration lock
Configure exclusively locked by the following line:
Line : vty 0
Line number : 2
User : admin
Type : AUTO
State : LOCKED
Ip address : 10.11.9.97
port number
(OPTIONAL) Enter the port number to display traffic statistics on that port only.
Range: 1 to 1568
all (OPTIONAL) Enter the keyword all to display traffic statistics on all the interfaces
receiving traffic, sorted based on traffic.
Version 8.3.17.0 Supported on M I/O Aggregator