Reference Guide

48 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
See parameters above.
Command Modes
EXEC
EXEC Privilege
Command
History
source Enter the IPv4 source ip address or the source interface.
• Enter the IP address in A.B.C.D format
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
tos
Enter the type of service required.
Range: 0-255
Default: 0
df-bit
Enter Y or N for the don't fragment bit in IPv4 header
• N: Do not set the don't fragment bit
•Y: Do set don't fragment bit
Default is No.
validate-reply
Enter Y or N for reply validation.
• N: Do not validate reply data
• Y: Do validate reply data
Default is No.
pattern pattern
Enter the IPv4 data pattern.
Range: 0-FFFF
Default: 0xABCD
sweep-min-size
Enter the minimum size of datagram in sweep range.
Range: 52-15359 bytes
sweep-max-size
Enter the maximum size of datagram in sweep range.
Range: 53-15359 bytes
sweep-interval
Enter the incremental value for sweep size.
1-15308 seconds
ointerface
Enter the outgoing interface for multicast packets.
• Enter the IP address in A.B.C.D format
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.17.0 Supported on M I/O Aggregator