Reference Guide

46 | Control and Monitoring

www.dell.com | support.dell.com

Command

History

ip telnet server enable

Enable the Telnet server on the switch.

Syntax

ip telnet server enable

To disable the Telnet server, use the no ip telnet server enable command.

Defaults

Enabled

Command Modes

CONFIGURATION

Command

History

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

Syntax

ip telnet source-interface interface

Parameters

Defaults

The IP address on the system that is closest to the Telnet address is used in the outgoing packets.

Command Modes

CONFIGURATION

Command

History

Commands

line

Enable and configure console and virtual terminal lines to the system. This command accesses LINE

mode, where you can set the access conditions for the designated line.

Syntax

line {console 0 | vty number [end-number]}

Version 8.3.17.0 Supported on M I/O Aggregator

interface

Enter the following keywords and slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by

the slot/port information.

• For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094.

Version 8.3.17.0 Supported on M I/O Aggregator

telnet Telnets to another device.