Reference Guide

244 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
enable
Re-enable upstream-link tracking for an uplink-state group after it has been disabled.
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the no enable command.
Parameters
Defaults
Upstream-link tracking is automatically enabled in an uplink-state group.
Command Modes
UPLINK-STATE-GROUP
Command
History
group-id Enables debugging on the specified uplink-state group. Valid group-id values
are 1 to 16.
Version 9.2(0.0) Introduced on the M I/O Aggregator.