Reference Guide

230 | Stacking Commands
www.dell.com | support.dell.com
show system stack-unit stack-group
Displays the stack-groups present/configured for a M I/O Aggregator stack unit.
Syntax
show system stack-unit <unit-number> stack-group [configured]
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Related
Commands
Example
Figure 21-6. show system stack-unit stack-group Command Example
stack-unit iom-mode
Toggle the M I/O Aggregator operating mode between programmable multiplex, stand-alone, stack,
and VLT modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack | standalone | vlt]
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5.
Version 8.3.17.0 Supported on M I/O Aggregator
reload Reboots FTOS.
show system Displays the current status of all stack members or a specific member.
FTOS#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
FTOS#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
FTOS##show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/33
1 0/37
2 0/41
3 0/45
FTOS#
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5.
programmable-
mux
Enable programmable multiplex mode.
stack
Enable stack mode.
standalone
Enable stand-alone mode.
vlt
Enable virtual link trunking mode.