Reference Guide

Stacking Commands | 229
Example
show system stack-unit iom-mode Example show system stack-unit fanout
Displays the current 40GbE ports configured in fanout mode.
Syntax
show system stack-unit <unit-number> fanout [configured]
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Example
Figure 21-5. show system stack-unit fanout Command Example
FTOS#show system stack-unit all iom-mode ?
| Pipe through a command
<cr>
FTOS#show system stack-unit all iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 stack stack
1 stack stack
2 stack stack
3 stack stack
4 Not Present
5 Not Present
FTOS#
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#show system stack-unit 0 fanout ?
configured Configured fan out ports
FTOS#show system stack-unit 0 fanout configured ?
| Pipe through a command
<cr>
FTOS#show system stack-unit 0 fanout configured
Configured fan out ports in stack-unit 0
Configured Next Boot
33 33
37 37
41 41
45 45
FTOS#