Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator
211212213214215216217218219220
210 | Security
www.dell.com | support.dell.com
Table 1 describes the information in the show users command example.
Related
Commands
ssh
Open an SSH connection specifying the hostname, username, port number and version of the SSH
client.
FTOS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound SSH
supports accessing the system through the management interface as well as through a physical Layer 3
interface.
Syntax
ssh {hostname | ipv4 address} [-l username | -p port-number | -v {1 | 2}]
Parameters
Defaults
As above.
Command Modes
EXEC Privilege
Command
History
Example
Figure 19-5. ssh Command Example
Table 1 show users Command Description
Field Description
(untitled) Indicates with am asterisk (*) which terminal line you are using.
Line Displays the terminal lines currently in use.
User Displays the user name of all users logged in.
Host(s) Displays the terminal line status.
Location Displays the IP address of the user.
ssh Enables a user.
hostname
(OPTIONAL) Enter the IP address or the hostname of the remote device.
ipv4 address
(OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
-l username (OPTIONAL) Enter the keyword -l followed by the user name used in this SSH
session.
Default: The user name of the user associated with the terminal.
-p port-number
(OPTIONAL) Enter the keyword -p followed by the port number.
Range: 1 to 65536
Default: 22
-v {1 | 2}
(OPTIONAL) Enter the keyword -v followed by the SSH version 1 or 2.
Default: The version from the protocol negotiation
Version 8.3.17.0 Supported on M I/O Aggregator