Reference Guide

200 | Port Monitoring
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 17-3. show monitor session Command Example
Related
Commands
show running-config monitor session
Displays the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use just the show running-config
monitor session
command.
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 17-4. show running-config monitor session Command Example
Usage
Information
The monitoring command is saved in the running configuration at the Monitor Session mode level and
can be restored after a chassis reload.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#show monitor session 5
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
5 Te 0/4 Te 0/43 rx interface Port-based
FTOS#
monitor session Creates a session for monitoring.
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#show run monitor session
!
monitor session 5
source TenGigabitEthernet 0/4 destination TenGigabitEthernet 0/43 direction rx
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/42 direction both
FTOS#
FTOS#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/42 direction both
FTOS#