Reference Guide

140 | Interfaces
www.dell.com | support.dell.com
interface vlan
Configure the default VLAN to enable Static or DCHP IP configuration
Syntax
interface vlan def-vlan-id
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
For more information about VLANs and the commands to configure them, refer to Virtual LAN
(VLAN) Commands.
Example
Figure 11-11. interface vlan Command Example
Related
Commands
keepalive
Keep the interface alive when it is not transmitting data.
Syntax
keepalive
Defaults
Enabled
Command Modes
INTERFACE
Command
History
Usage
Information
When you configure keepalive, the system keeps the link is up even if the link is not active at the time.
def-vlan-id
Enter 1 for the default VLAN.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS(conf)#int vlan 1
FTOS(conf-if-vl-1)#
show vlan Displays the current VLAN configuration on the switch.
vlan tagged Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged Adds a Layer 2 interface to a VLAN as an untagged interface.
Version 8.3.17.0 Supported on M I/O Aggregator