Reference Guide

Before You Start | 11
Aggregator ports that you manually configured for VLAN membership in stacking mode retain their
VLAN configuration in standalone mode.
To restore the default auto-VLAN mode of operation (in which all ports are members of all 4094
VLANs) on a port, enter the auto vlan command; for example:
To get the default standalone mode configurations:
1. Delete the startup-config file and reboot the system.
2. Restore to factory default settings.
3. Configure
auto vlan command on all the server ports.
Where to Go From Here
You can customize the Aggregator for use in your data center network as necessary. To perform
additional switch configuration, do one of the following:
• For remote out-of-band management, enter the OOB management interface IP address into a
Telnet or SSH client and log in to the switch using the user ID and password to access the CLI.
• For local management using the CLI, use the attached console connection.
• For remote in-band management from a network management station, enter the VLAN IP address
of the management port and log in to the switch to access the CLI.
If you installed the Aggregator in a stack, you can configure additional settings for switch stacking.
In case of an FTOS upgrade, you can check to see that an Aggregator is running the latest FTOS
version by entering the show version command. To download an FTOS version, go to http://
support.dell.com.
Refer to the appropriate chapter for detailed information on how to configure specific software
settings.
FTOS(conf)# interface tengigabitethernet 0/2
FTOS(conf-if-te-0/2)# auto vlan