Concept Guide

Parameters
description Enter a text string description to identify the VLAN (80 characters maximum).
Command Modes INTERFACE
Supported Modes Standalone Mode
Usasge Information The auto vlan command adds the port as untagged to default vlan and tagged to all other 4094 VLAN.
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults Not congured.
Command Modes INTERFACE PORTCHANNEL
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP address in its conguration.
Link MTU and IP MTU considerations for Port Channels are:
• All members must have the same link MTU value and the same IP MTU value.
• The Port Channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
congured on the channel members. For example, if the members have a link MTU of 2100 and an IP MTU
2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
When an interface is removed from a Port Channel with the no channel-member command, the interface
reverts to its conguration prior to joining the Port Channel.
Interfaces 195