Administrator Guide

Defaults None
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The type may be auto, manual, or rollback. When set to auto, Dell Networking OS
automatically denies access to CONFIGURATION mode to all other users every
time the user on the listed VTY line enters CONFIGURATION mode. When set to
manual, the user on the listed VTY line must explicitly set the lock each time before
entering CONFIGURATION mode. Rollback indicates that Dell Networking OS is in
a rollback process. The line number shown in the output can be used to send the
messages to that session or release a lock on a VTY line.
Example
Dell#show configuration lock
Configure exclusively locked by the following line:
Line : vty 0
Line number : 2
User : admin
Type : AUTO
State : LOCKED
Ip address : 10.11.9.97
Dell#
show cpu-traffic-stats
Display the CPU traffic statistics.
Syntax
show cpu-traffic-stats [port number | all]
Parameters
port number (OPTIONAL) Enter the port number to display traffic statistics
on that port only. The range is from 1 to 1568.
all (OPTIONAL) Enter the keyword all to display traffic
statistics on all the interfaces receiving traffic, sorted based
on the traffic.
Defaults all
Command
Modes
EXEC
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
Traffic statistics are sorted on a per-interface basis; the interface receiving the most
traffic is displayed first. All CPU and port information is displayed unless a specific
port or CPU is specified. Traffic information is displayed for router ports only; not
for management interfaces. The traffic statistics are collected only after the debug
cpu-traffic-stats command is executed; not from the system bootup.
62
Control and Monitoring