Administrator Guide

Usage
Information
If there is a change in the configuration, the Dell Networking OS prompts you to
save the new configuration. Or you can save your running configuration with the
copy running-config command.
Related
Commands
reset stack-unit — resets any designated stack member except the management
unit.
service timestamps
Add time stamps to debug and log messages. This command adds either the uptime or the current time
and date.
Syntax
service timestamps [debug | log] [datetime [localtime] [msec]
[show-timezone] | uptime]
Parameters
debug (OPTIONAL) Enter the keyword debug to add timestamps to
debug messages.
log (OPTIONAL) Enter the keyword log to add timestamps to
log messages with severity from 0 to 6.
datetime (OPTIONAL) Enter the keyword datetime to have the
current time and date added to the message.
localtime (OPTIONAL) Enter the keyword localtime to include the
localtime in the timestamp.
msec (OPTIONAL) Enter the keyword msec to include milliseconds
in the timestamp.
show-
timezone
(OPTIONAL) Enter the keyword show-timezone to include
the time zone information in the timestamp.
uptime (OPTIONAL) Enter the keyword uptime to have the
timestamp based on time elapsed since system reboot.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
If you do not specify parameters and enter service timestamps, it appears as
service timestamps debug uptime in the running-configuration.
To view the current options set for the service timestamps command, use the
show running-config command.
Control and Monitoring
59