Administrator Guide

Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging monitor— sets the logging parameters on the monitor/terminal.
Storm Control
The Dell Networking operating software storm control feature allows you to limit or suppress traffic
during a traffic storm.
Important Points to Remember
• Interface commands can only be applied on physical interfaces (virtual local area networks [VLANs]
and link aggregation group [LAG] interfaces are not supported).
• An INTERFACE-level command only supports storm control configuration on ingress.
• An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that
physical interface, if both are configured.
• You can apply the CONFIGURATION-level storm control commands at ingress or egress and are
supported on all physical interfaces.
• When storm control is applied on an interface, the percentage of storm control applied is calculated
based on the advertised rate of the line card. It is not based on the speed setting for the line card.
• Do not apply per-VLAN quality of service (QoS) on an interface that has storm control enabled (either
on an interface or globally).
• When you enable broadcast storm control on an interface or globally on ingress, and DSCP marking
for a DSCP value 1 is configured for the data traffic, the traffic goes to queue 1 instead of queue 0.
448
PMUX Mode of the I/O Aggregator