Administrator Guide

Usage
Information
There are four queues per interface on the MXL switch. This command assigns a
class map or QoS policy to different queues.
Related
Commands
service-policy output — applies an output policy map to the selected interface.
show qos qos-policy-output
View the output QoS policy details.
Syntax
show qos qos-policy-output [qos-policy-name]
Parameters
qos-policy-
name
Enter the QoS policy name.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show qos qos-policy-output
Qos-policy-output qmap_out
Bandwidth-percentage 10
Qos-policy-output qmap_wg
Rate-shape 100 50
Wred yellow wy
Wred green wg
Dell#
Simple Network Management Protocol (SNMP) and
Syslog
This chapter contains commands to configure and monitor the simple network management protocol
(SNMP) v1/v2/v3 and Syslog.
The chapter contains the following sections:
• SNMP Commands
• Syslog Commands
SNMP Commands
The following SNMP commands are available in the Dell Networking operating software.
The simple network management protocol (SNMP) is used to communicate management information
between the network management stations and the agents in the network elements. Dell Networking OS
supports SNMP versions 1, 2c, and 3, supporting both read-only and read-write modes. Dell Networking
PMUX Mode of the I/O Aggregator
435