Administrator Guide

Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the
service-policy for those interfaces. A policy map attached to an interface can be
modified.
Related
Commands
policy-map-output — creates an output policy map.
service-queue
Assign a class map and QoS policy to different queues.
Syntax
service-queue queue-id [class-map class-map-name] [qos-policy
qos-policy-name]
To remove the queue assignment, use the no service-queue queue-id
[class-map class-map-name] [qos-policy qos-policy-name]
command.
Parameters
queue-id Enter the value used to identify a queue. The range is from 0
to 3 (four queues per interface; four queues are reserved for
control traffic).
class-map
class-map-
name
(OPTIONAL) Enter the keyword class-map then the class
map name assigned to the queue in character format (32
character maximum).
NOTE: This option is available under policy-map-
input only.
qos-policy
qos-policy-
name
(OPTIONAL) Enter the keywords qos-policy then the QoS
policy name assigned to the queue in text format (32
characters maximum). This specifies the input QoS policy
assigned to the queue under policy-map-input and
output QoS policy under policy-map-output context.
Defaults none
Command
Modes
CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
434
PMUX Mode of the I/O Aggregator