Administrator Guide

Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-
name
Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To specify the name of the output QoS policy, use this command. After the output
policy is specified, rate shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables Qos-Policy-Output Configuration mode —
(conf-qos-policy-out).
432
PMUX Mode of the I/O Aggregator