Administrator Guide

Command
Modes
CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
and conf-qos-policy-out; wred)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
policy-map-output — creates an output policy map.
qos-policy-output — creates an output QoS-policy on the router.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Enter the name of the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If the rate shape exists in both aggregate and per-queue qos-policy, minimum of
two take effect. Some of all Queue-rate will not exceed aggregate.
Related
Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
PMUX Mode of the I/O Aggregator
431