Administrator Guide

Example
Dell(conf)#interface TenGigabitethernet 3/15
Dell(conf-if-tengig-3/15)#no shutdown
Dell(conf-if-tengig-3/15)#port-channel-protocol lacp
Dell(conf-if-tengig-3/15-lacp)#port-channel 32 mode active
...
Dell(conf)#interface TenGigabitethernet 3/16
Dell(conf-if-tengig-3/16)#no shutdown
Dell(conf-if-tengig-3/16)#port-channel-protocol lacp
Dell(conf-if-tengig-3/16-lacp)#port-channel 32 mode active
Link Layer Discovery Protocol (LLDP)
Link layer discovery protocol (LLDP) advertises connectivity and management from the local station to
the adjacent stations on an IEEE 802 LAN.
LLDP facilitates multi-vendor interoperability by using standard management tools to discover and make
available a physical topology for network management. The Dell Networking operating software
implementation of LLDP is based on IEEE standard 801.1ab.
The starting point for using LLDP is invoking LLDP with the protocol lldp command in either
CONFIGURATION or INTERFACE mode.
The information LLDP distributes is stored by its recipients in a standard management information base
(MIB). You can access the information by a network management system through a management
protocol such as simple network management protocol (SNMP).
For details about implementing LLDP/LLDP-MED, refer to the Link Layer Discovery Protocol chapter of
the Dell Networking OS Configuration Guide.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size}
command.
Parameters
max-frame-
size
Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Defaults none
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the I/O Aggregator
421