Administrator Guide

untagged, V - VLT tagged
Name: TenGigabitEthernet 0/2
802.1QTagged: Hybrid
IO-AGG port mode: Admin VLANs enabled
Vlan membership:
Q Vlans
U 1
Native VlanId: 1.
Dell(conf-if-te-0/2)#
Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2)
interfaces on the switch.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
stack-unit portmode
Split a single 40G port into 4-10G ports on the MXL switch.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. The range is 0 to 5.
NOTE: The MXL switch commands accept Unit ID
numbers from 0 to 5, though the MXL switch supports
stacking up to three units only with the Dell Networking
OS version 8.3.7.1.
number Enter the port number of the 40G port to be split. Enter one
of the following port numbers for the MXL switch: 48, 52, 56,
or 60.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Splitting a 40G port into 4x10G port is supported on standalone and stacked units.
• You cannot use split ports as stack-link to stack an MXL Switch.
• The split ports MXL switch unit cannot be a part of any stacked system.
PMUX Mode of the I/O Aggregator
403