Administrator Guide

interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet, then the slot
number 0 and port number zero (0).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the
ip address command.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
interface
Configure a physical interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Fibre Channel interface, enter the keyword
FibreChannel, then the slot/port information.
Defaults Not configured.
Command
Modes
CONFIGURATION
PMUX Mode of the I/O Aggregator
393