Administrator Guide

iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is
monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters
tcp-
port-2...tcpport
- 16
Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is
860,
3260.
ip-address (Optional) Enter the ip-address that the iSCSI monitors. The
ip-address specifies the IP address of the iSCSI target.
Defaults 860, 3260
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or
multiple commands.
When you use the no iscsi target port command and the TCP port you wish
to delete is one bound to a specific IP address, the IP address value must be
included in the command.
Interfaces
The commands in this chapter are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
388
PMUX Mode of the I/O Aggregator