Administrator Guide

Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable the iSCSI feature using the iscsi enable command, flow
control settings are set to
rx on tx off on all interfaces.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits
command.
Defaults 4 (0x10 in the bitmap)
Command
Modes
PROTOCOL LLDP (only on the global, not on the interface)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the I/O Aggregator
387