Administrator Guide

FIP Snooping
Commands
The following Dell Networking OS commands are used to configure and verify the
FIP snooping feature:
• debug fip-snooping
• show fip-snooping config
• show fip-snooping enode
• show fip-snooping fcf
• show fip-snooping sessions
• show fip-snooping statistics
• show fip-snooping system
clear fip-snooping database interface vlan
Clear FIP snooping information on a VLAN for a specified FCoE MAC address, ENode MAC address, or
FCF MAC address, and remove the corresponding ACLs FIP snooping generates.
Syntax
clear fip-snooping database interface vlan vlan-id {fcoe-mac-
address | enode-mac-address | fcf-mac-address}
Parameters
fcoe-mac-
address
Enter the FCoE MAC address to be cleared of FIP snooping
information.
enode-mac-
address
Enter the ENode MAC address to be cleared of FIP snooping
information.
fcf-mac-
address
Enter the FCF MAC address to be cleared of FIP snooping
information.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear fip-snooping statistics
Clears the statistics on the FIP packets snooped on all VLANs, a specified VLAN, or a specified port
interface.
Syntax
clear fip-snooping statistics [interface vlan vlan-id |
interface port-type port/slot | interface port-channel port-
channel-number]
Parameters
vlan-id Enter the VLAN ID of the FIP packet statistics to be cleared.
port-type port/
slot
Enter the port-type and slot number of the FIP packet
statistics to be cleared.
382
PMUX Mode of the I/O Aggregator