Administrator Guide

Defaults 0x8
Command
Modes
PROTOCOL LLDP
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is available at the global level only.
fcoe-map
Create an FCoE map which contains the parameters used to configure the links between server CNAs
and a SAN fabric. Apply the FCoE map on a server-facing Ethernet port.
M I/O Aggregator with the PMUX module
Syntax
fcoe-map map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults On the I/O Aggregator with PMUX modules, the following parameters are applied
on all the PMUX module interfaces:
• Description: SAN_FABRIC
• Fabric-id: 1002
• Fcoe-vlan: 1002
• Fc-map: 0x0efc00
• Fcf-priority: 128
• Fka-adv-period: 8000mSec
• Keepalive: enable
• Vlan priority: 3
Command
Modes
CONFIGURATION
INTERFACE
Command
History
Version 9.3(0.0) Introduced on the M I/O Aggregator with the PMUX module.
Usage
Information
An FCoE map is a template used to map FCoE and FC parameters in a converged
fabric. An FCoE map is used to virtualize upstream FC ports on an M I/O
Aggregator and MXL 10/40GbE Switch with the PMUX module NPIV proxy gateway
so that they appear to downstream server CNA ports as FCoE forwarder (FCF) ports
on an FCoE network. When applied to FC and Ethernet ports on an NPIV proxy
gateway, an FCoE map allows the switch to operate as an FCoE-FC bridge
PMUX Mode of the I/O Aggregator
357