Administrator Guide

Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you apply an ETS output policy to on interface, ETS-configured scheduling
and bandwidth allocation take precedence over any configured settings in QoS
output policies.
To remove an ETS output policy from an interface, use the no dcb-policy
output policy-name
command. ETS is enabled by default with the default ETS
configuration applied (all dot1p priorities in the same group with equal bandwidth
allocation).
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
FC Flex IO Modules with I/O Aggregator
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all
command.
Parameters
dcb-map-
name
Enter the name of the DCB map.
Defaults None
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O
Aggregator.
Usage
Information
The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
Related
Commands
dcb-map – creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
dcb-policy input stack-unit stack-ports all
Apply the specified DCB input policy on all ports of the switch stack or a single stacked switch.
Syntax
dcb-policy input stack-unit {all | stack-unit-id} stack-ports
all dcb-input-policy-name
350
PMUX Mode of the I/O Aggregator