Administrator Guide

PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
DCB Command
The following DCB command is supported on the FC Flex IO module installed in the M I/O Aggregator.
dcb-enable
Enable data center bridging.
Syntax
dcb enable
To disable DCB, use the no dcb enable command.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator.
Usage
Information
DCB is not supported if you enable link-level flow control on one or more
interfaces.
DCBX Commands
The following DCBX commands are supported on the FC Flex IO module installed in the M I/O
Aggregator.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to
DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-
tlv {fcoe | iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
FC Flex IO Modules
321