Administrator Guide

stack. The range is from 0 to 5. The second instance of this
value is the desired new unit identifier number.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the M I/O Aggregator
Usage
Information
You can renumber any switch, including the management unit or a stand-alone
unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the
members are renumbered, only that specific unit is reset and comes up with the
new unit number.
Example
Dell#stack-unit 5 renumber 4
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
• reload – reboots Dell Networking Operating System (OS).
• reset stack-unit – resets the designated S-Series stack member.
• show system – displays the current status of all stack members or a specific
member.
280
Stacking Commands