Administrator Guide

and then plug in the stacking cable for the changes to take
effect.
Dell(conf)#
Dell#
Related
Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specific
member.
stack-unit iom-mode uplink-speed
Specify the uplink speed of the member interfaces in a LAG bundle for the Aggregator that operates in
standalone, stacking, or VLT mode to be 40 GbE. By default, the uplink speed of the LAG bundle is set as
10 GbE.
Syntax
stack-unit unit-number iom-mode {stack | standalone | vlt}
uplink-speed 40G
To restore the default uplink speed of the LAG bundle, which is 10 GbE, use the
stack-unit unit-number iom-mode {stack | standalone | vlt}
command.
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5.
iom-mode Denotes the operating mode of the I/O Aggregator.
stack Specify that the uplink speed of the member interfaces in a
LAG bundle applies for the Aggregator in stacking mode
standalone Specify that the uplink speed of the member interfaces in a
LAG bundle applies for the Aggregator in standalone mode
vlt Specify that the uplink speed of the member interfaces in a
LAG bundle applies for the Aggregator in VLT mode
uplink-speed
40G
Set the uplink speed of the member or child interfaces of the
LAG bundle to function at 40 Gigabit Ethernet per second
Command
Modes
CONFIGURATION
Command
History
Version 9.3.0.0 Introduced on the M I/O Aggregator
Usage
Information
This functionality to set the uplink speed is available from the CMC interface when
the I/O Aggregator functions as a simple MUX or a VLT node with all of the uplink
interfaces configured to be member links in the same LAG bundle. You cannot
configure the uplink speed to be set as 40 GbE by default if the Aggregator
functions in programmable MUX mode with mutiple uplink LAG interfaces or in
278
Stacking Commands