Administrator Guide

Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/33
1 0/37
2 0/41
3 0/45
Dell#
Related
Commands
reload— reboots the system.
show system— displays the current status of all stack members or a specific
member.
stack-unit iom-mode
Toggle the M I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and
VLT modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack |
standalone | vlt]
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5.
programmable
-mux
Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command
Modes
• CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
Stacking Commands
277