Administrator Guide

Fanout ENABLED
3:Task(tUsrRoot): [ 24038]SS DRV DEBUG: port:32 isfanout:1
4:Task(tUsrRoot): [ 27]SS DRV DEBUG: port:36 isfanout:1
5:Task(tUsrRoot): [ 19]SS DRV DEBUG: port:40 isfanout:0
6:Task(tUsrRoot): [ 17]SS DRV DEBUG: port:44 isfanout:0
7:Task(tUsrRoot): [ 22]SS DRV DEBUG: port:48 isfanout:1
8:Task(tUsrRoot): [ 22]SS DRV DEBUG: port:52 isfanout:1
9:Task(tUsrRoot): [ 33]SS DRV DEBUG: Appl init complete
10:Task(tUsrRoot): [ 2590]SS DRV DEBUG: Util Init complete
11:Task(tUsrRoot): [ 21]SS DRV DEBUG: Device Entry Get Complete
12:Task(tUsrRoot): [ 25]SS DRV DEBUG: Sysconf init complete
13:Task(tUsrRoot): [ 19]SS DRV DEBUG: Initializing default soc/
sal
configs
14:Task(tUsrRoot): [ 237]SS DRV DEBUG: sysconf probe complete
15:Task(tUsrRoot): [ 118]SS DRV DEBUG: Updating based on Optm
16:Task(tUsrRoot): [ 10351]SS DRV DEBUG: Updating based on
Fanout
17:Task(tUsrRoot): [ 2561]SS DRV DEBUG: unit 0 localWc6 speed10
18:Task(tUsrRoot): [ 24]SS DRV DEBUG: unit 0 localWc5 speed10
19:Task(tUsrRoot): [ 21]SS DRV DEBUG: unit 0 localWc3 speed40
20:Task(tUsrRoot): [ 18]SS DRV DEBUG: unit 0 localWc2 speed40
terminal monitor
Configure the Dell Networking OS to display messages on the monitor/terminal.
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
defaults Disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
logging monitor— sets the logging parameters on the monitor/terminal.
270
Simple Network Management Protocol (SNMP) and Syslog