Administrator Guide

• logging console
• logging hostname
• logging monitor
• logging source-interface
• logging trap
• show logging
• terminal monitor
clear logging
Clear the messages in the logging buffer.
Syntax
clear logging
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
show logging— displays logging settings and system messages in the internal
buffer.
logging buffered
Enable logging and specify which messages are logged to an internal buffer. By default, all messages are
logged to the internal buffer.
Syntax
logging buffered [level] [size]
To return to the default values, use the no logging buffered command.
To disable logging stored to an internal buffer, use the no logging buffered
command.
Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following equivalent words: emergencies, alerts,
critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or
debugging.
size (OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
each message. The range is from 40960 to 524288. The
default is 40960 bytes.
264
Simple Network Management Protocol (SNMP) and Syslog