Administrator Guide

Field Description
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address.
Gateway Identifies whether the route is directly connected and on
which interface the route is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Example
(Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
Dell#show ip route static ?
| Pipe through a command
<cr>
Dell#show ip route static
Destination Gateway Dist/Metric
Last Change
----------- ------- -----------
-----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0
3d2h
Dell#
show tcp statistics
View information on TCP traffic through the switch.
Syntax
show tcp statistics
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show tcp statistics cp command shown in the
following example.
202
IPv4 Routing