Administrator Guide

management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address}/mask{forwarding-router-address
| managementethernet}
Parameters
{ipv4-address}/
mask
Enter an IPv4 address (A.B.C.D) followed by the prefix-length
for the IP address of the management interface.
forwarding-
router-address
Enter an IPv4 address of a forwarding router.
managementet
hernet
Enter the keyword managementethernet for the
Management interface.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 management routes. This command manages both tables.
show arp
Displays the ARP table.
Syntax
show arp [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [static | dynamic]
[summary]
Parameters
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
managementethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
194
IPv4 Routing