Administrator Guide

Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
Untagged interfaces can only belong to one VLAN.
In the default VLAN, you cannot use the no untagged interface command. To
remove an untagged interface from all VLANs, including the default VLAN, enter
INTERFACE mode and use the no vlan tagged command.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
When two or more ports configured for VLANs form a LAG, the resulting LAG is a
tagged member of all the configured VLANs and an untagged member of the VLAN
to which the port with the lowest port ID belongs.
For example, if port 0/33 is an untagged member of VLAN 2 and port 0/41 is an
untagged member of VLAN 3, the resulting LAG consisting of the two ports is an
untagged member of VLAN 2 and a tagged member of VLANs 2 and 3.
Example
Dell(conf-if-te-0/2)#vlan untagged ?
<1-4094> Untagged VLAN id
Dell(conf-if-te-0/2)#
Dell(conf-if-te-0/2)#vlan untagged 4094
Dell(conf-if-te-0/2)#show config
!
interface TenGigabitEthernet 0/2
mtu 12000
vlan untagged 4094
!
port-channel-protocol LACP
port-channel 1 mode active
!
protocol lldp
advertise management-tlv system-name
dcbx port-role auto-downstream
no shutdown
Dell(conf-if-te-0/2)#
Related
Commands
interface vlan —Configures a VLAN.
188
Interfaces