Administrator Guide

show ip interface— Displays the interface routing status. Add the keyword brief to
display a table of interfaces and their status.
speed (for 1000/10000 interfaces)
Set the speed for 1000/10000 Base-T Ethernet interfaces. Both sides of a link must be set to the same
speed (1000/10000) or to auto or the link may not come up.
Syntax
speed {1000 | 10000 | auto}
To return to the default setting, use the no speed {1000 | 10000 |auto}
command.
Parameters
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to
10000 Mb/s. Auto-negotiation is enabled. For more
information, refer to
name
auto Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to name.
Defaults auto
Command
Modes
INTERFACE
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
This command is found on the 1000/10000 Base-T Ethernet interfaces.
When you enable auto, the system performs and automatic discovery to
determine the optics installed and configure the appropriate speed.
When you configure a speed for the 1000/10000 interface, confirm the
negotiation auto command setting. Both sides of the link must should have
auto-negotiation either enabled or disabled. For speed settings of 1000 or auto,
the software sets the link to auto-negotiation and you cannot change that setting.
Related
Commands
negotiation auto — enables or disables auto-negotiation on an interface.
Interfaces
185