Administrator Guide

• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan followed
by a number from 1 to 4094.
• For a Port Channel interface, enter the keyword port-
channel
followed by a number. The range is from 1 to
128.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.6.
(0.0)
Added support for Auto-LAG on the M I/O Aggregator.
Version 8.3.17.0 Supported on the M I/O Aggregator
Usage
Information
Use this show interfaces command for details on a specific interface. Use the
show interfaces stack-unit command for details on all interfaces on the
designated stack unit.
On the M I/O Aggregator, the show interface output displays incorrect rate
information details over time for link monitoring when the rate-interval is
configured for 5 seconds. Dell Networking recommends using higher rate-intervals
such as 15 to 299 seconds to minimize the errors seen.
NOTE: In the CLI output, the power value will be rounded to a 3-digit value.
For receive/transmit power that is less than 0.000, an snmp query will return
the corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until
it reaches the maximum line rate. When the maximum line rate is reached,
there will be no change in the line-rate.
User
Information
The following describes the show interfaces command shown in the 10G
example below.
Line Description
TenGigabitEthern
et 2/0...
Displays the interface’s type, slot/port, and administrative
and line protocol status.
Hardware is... Displays the interface’s hardware information and its
assigned MAC address.
Interface index... Displays the interface index number used by SNMP to
identify the interface.
Interfaces
169