Administrator Guide

interface vlan
Configure the default VLAN to enable Static or DCHP IP configuration
Syntax
interface vlandef-vlan-id
Parameters
def-vlan-id Enter 1 for the default VLAN.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
For more information about VLANs and the commands to configure them, refer to
Virtual LAN (VLAN) Commands.
Example
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Related
commands
show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg
command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces
157