Administrator Guide

off off off off
off off off off
off off off off
off off off off
off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related
Commands
show running-config— displays the flow configuration parameters (non-default
values only).
show interfaces — displays the negotiated flow control parameters.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number
Enter an integer from 1 to 32 that will uniquely identify this
LAG fate-sharing group.
port-channel
number
Enter the keyword port-channel followed by an existing LAG
number.
Enter this keyword/variable combination twice, identifying
the two LAGs to be paired.
Defaults none
Command
Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
152
Interfaces