Administrator Guide

Default None.
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
information
The renew dhcp command is used to renew the lease of IP address obtained
through dhcp.
To display the currently configure dynamic IP address and lease time, enter the
show ip dhcp lease command.
show ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
show ip dhcp client statistics {all | interface type slot/port}
Parameters
all Display DHCP client statistics on all DHCP client-enabled
interfaces on the switch.
interface type
slot/port
Display DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter
the keyword management ethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command
Modes
EXEC Privilege
Default None.
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
show ip dhcp lease
Displays lease information about the dynamic IP address currently assigned to a DHCP client-enabled
interface.
Syntax
show ip dhcp lease[interface type slot/port]
Parameters
interface type
slot/port
Display DHCP client statistics on the specified interface.
Dynamic Host Configuration Protocol
125