Users Guide

Pluggable media not present
Interface index is 1048580
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :f8b1566efc59
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:26:42
Queueing strategy: fifo
Input Statistics:
941 packets, 98777 bytes
83 64-byte pkts, 591 over 64-byte pkts, 267 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
694 Multicasts, 247 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
1474 packets, 238933 bytes, 0 underruns
0 64-byte pkts, 204 over 64-byte pkts, 1071 over 127-byte pkts
175 over 255-byte pkts, 24 over 511-byte pkts, 0 over 1023-byte pkts
1198 Multicasts, 276 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:00:17
NOTE: For more information on Uplink Failure Detection and all other conguration settings, see the Uplink Failure
Detection (UFD) chapter.
Ensuring the FN IOM system is in Standalone Mode
To ensure that the FN IOM is in Standalone Mode, use the show system stack-unit 0 iom-mode command.
Dell#show system stack-unit 0 iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 standalone
If the FN IOM system is not in the Standalone Mode, reset the system to its factory default state. To reset the system, use the
restore factory-defaults stack-unit 0 clear-all command. It brings the system in standalone (precongured)
mode and sets all conguration settings to a known state.
Dell#restore factory-defaults stack-unit 0 clear-all
Proceed with factory settings? Confirm [yes/no]:y
Congure Interfaces and Port Channel
This section provides the commands for conguring port channels on common upstream switches that are connected to the FN
IOM system.
The previous illustration is applicable to the FN 410S and FN 410T servers. If you are using the FN 2210S server in its default
conguration, you can only use the TenGigabitethernet 0/11 and TenGigabitethernet 0/12 in the uplink port channel. Ports
TenGigabitethernet 0/9 and TenGigabitethernet 0/10 are Fibre Channel ports.
22
Before You Start